Powerfix Z31697A Manual do Utilizador descarregar pdf (Página 14)

14 GB/IE

Press the ON/OFF button

to switch the

device on.

Press the MODE button

repeatedly until

the symbol „

“ for volume measurement, as

well as the designation 0.00m (or 0‘00“),

appear in the display

. The symbol „ “

for length measurement ﬂashes. The device

displays in this way, that it is ready for the ﬁrst

measurement.

Align the device and press the READ button

If the measurement is successful, the length

will appear at the top of the display. The

symbol for width measurement „

“ also

ﬂashes. The device displays in this way, that it

is ready for the measurement of the width.

Align the device and press the READ button.

If the measurement is successful, the width

will appear at the top of the display. The

symbol for height measurement „

“ also

ﬂashes. The device displays in this way, that it

is ready for the measurement of the height.

Align the device and press the READ button

again. If the measurement is successful, the

height appears at the top of the display, and

at the bottom appears the volume in the m

unit of measurement (or cu.ft = cubic feet).

Press the MODE button brieﬂy, if a further

volume measurement is required. The ﬁgures

in the display are reset, and the device is

ready for a new volume measurement.

Adding surface areas or

volumes together

Measure a surface area or volume as de-

scribed in the section „Measuring surface

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 103 104

Sem comentários

Powerfix Z31697A Manual do Utilizador Página 14